Re-attaching Tank Badges

[seforeman]

Does anyone know the recommended adhesive or foam tape to re-attach the side badges with? Any assistance / advise would be greatly recommended.

 

Thanks.

 

Stu

[bikenut]

Any 3M double sided car tape will work. Go to a paint store for cars and they will have it. I found that the 3M worked best for me.

Hope this helps:fingers-crossed-emo

[Jonesboy]

I found 3M at WalMart......

[09RSTD]

3M is best stuf on the entire extended planet. I hope that you never want to get those side badges off again though. You'll be forced to grind them off with a grinder.:rotf:

[Condor]

I'm not sure what the tape was that I used, but I did pick it up from a commercial auto paint store. I'm not worried about anything coming off.....

[bikenut]

If anyone has to remove any badges all you need is some fish line and just pull it thru the back side of the badge like a knife. Will not hurt the paint at all. Just a little tip I used many times removing car side moldings

[seforeman]

Thanks for the input, I will run out today and get some, or will find it online.

 

Stu

[PGunn]

I bought a roll of it at Home Depot for around $12.00 it's in the row where they have the adhesives and I found it on the floor under the shelf. They have 2 different roll sizes a 6ft I believe and a 12ft I bought the 12ft roll. The tape if you don’t know is a dark gray with a red removable backing and it is a 3M product, I have yet to find anything that comes close to this stuff when correctly applied. I’m using the stuff to hold relays, buss terminals and like in place. Make sure to pick up a spray can of wax and grease remover also it really is needed to make sure the stuff sticks. It also takes 24 hours for it to really “set” once it is stuck down.