Machinist/Tool Man advice needed

[Dragonslayer]

Who would be a source for an apparently Odd bolt thread tap. I'm looking for a M12 x 1.25 thread pitch and evidently it is not popular enough to be included in any of the tap and die sets I have been able to find so far.

 

I have already checked Sears, Harbor Frieght, Northern Tool and NAPA.... No luck

[Guest]

Who would be a source for an apparently Odd bolt thread tap. I'm looking for a M12 x 1.25 thread pitch and evidently it is not popular enough to be included in any of the tap and die sets I have been able to find so far.

 

I have already checked Sears, Harbor Frieght, Northern Tool and NAPA.... No luck

 

http://www.ebay.com/sch/i.html?_nkw=12mm+tap

 

You forgot FleaBay:smile5:

[Red Baron]

I have had issues finding metric taps and dies and achieved very good results on E-Bay.

I did a search and found

49 results found for tap m12 1.25

 

Just go to ebay and type this into the search engine and select all of ebay for the search:301:. Red Baron

[dingy]

McMaster carr

 

12 × 1.25D541 21/32"3 3/8"10.8 mm26015A231

 

Not cheap $21.11

 

Gary

[Flyinfool]

McMaster-Carr On left of page select your thread.

MSC Direct

Enco

 

There you go, lots to choose from

 

 

Wow I must type slow.........

[Guest]

HA, beat yous all and im on a 2nd gen........