Is Nothing Ever Easy?

[Bear1300]

Hi All,

 

Received my Barons Ultimate Light Bar recently. Amazing quality, very happy.

 

Just went to fit it only to find no wiring in the harness for driving lights!

 

Barons spell it out in the instructions that there should be a blue wire for the left and right driving lights as well as the the two left and right turn signals. Turn signal cabling is fine. Nothing to be seen for the driving lights! I have checked the loom in case it just wasnt run into the original light bar and nothing!

 

I can only assume its something to do with Australian compliance laws as I cannot imagine they would leave them out for any other reason. Not sure what people buying the Genuine Yamaha lightbar thought when they went to fit them also.

 

Now i will have to run a feed directly from the battery via a relay. Its just extra hassle i didnt want.

 

I just thought it was very bizzare.

 

Any other Aussie riders out there who have found the same issue?

[Yammer Dan]

I'm sure there are plenty on here that can help you. I don't speak 2nd Gen. I would wait for good advice before doing it.

[hunter 1500]

I wired mine so they were always on and then it was a lot of drain on battery so I have it so they just come on with the low beams.