hillrider Posted June 19, 2011 #1 Posted June 19, 2011 While pulling & greasing the steering head bearings, I found a small (3/16) hole leading to the upper frame member. Can anyone think of a good reason not to plug this hole. The thought is to put a zerk fitting on the side of the head and be done with pulling this bugger apart to grease the bearings. I think the hole is there to releave pressure while assembling the frame. Since the frame is complete - plug the hole.
royalstar09 Posted June 19, 2011 #2 Posted June 19, 2011 While pulling & greasing the steering head bearings, I found a small (3/16) hole leading to the upper frame member. Can anyone think of a good reason not to plug this hole. The thought is to put a zerk fitting on the side of the head and be done with pulling this bugger apart to grease the bearings. I think the hole is there to releave pressure while assembling the frame. Since the frame is complete - plug the hole. http://www.venturerider.org/forum/showthread.php?t=45540&highlight=hole+steering
hillrider Posted June 19, 2011 Author #3 Posted June 19, 2011 Thanks Royalstar. I hate being old. That being said, everyday has something new.
royalstar09 Posted June 20, 2011 #4 Posted June 20, 2011 Thanks Royalstar. I hate being old. That being said, everyday has something new. Not a problem. I tend to read a lot and I rembered something about that hole. Just went to second Generation section and searched for "steering hole" and it showed up
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now