tophatflyer Posted October 9, 2010 #1 Posted October 9, 2010 Hello! I just purchased a 1983 Venture and when I rode it home the idle stuck at about 2500. The bike starts and runs fine, but the idle will not slow down. Any suggestions?
safetyguy Posted October 9, 2010 #2 Posted October 9, 2010 You can try and ajdust the idle screw. Remove the left side cover. It is the downward pointed screw between the two sync screws. You should be able to turn it by hand - you don't need a screwdriver, but pliers may help to start it. Turn the idle screw counter clockwise and see if your idle goes down. Make sure you don't adjust the sync screws!!! (These need a screwdriver). Please look at attached photo
tophatflyer Posted October 10, 2010 Author #3 Posted October 10, 2010 Thanks much! Found it and adjusted it down. Went for a long great ride (it was GORGEOUS today in northeast Ohio). That seemed to take care of it. Thanks again!
Yammer Dan Posted October 10, 2010 #4 Posted October 10, 2010 I'd get some Sea-Foam in it soon. Something caused that idle to mess up. Spray some WD40 around the carbs to see if you have a vacum leak. It will rev up if you do.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now