slickster Posted October 3, 2010 Share #1 Posted October 3, 2010 Removed the fairing, (easy) and cleaned the audio plug with pin cleaner....if it happens again, what is the harm in doing away with the plug and soldering the wires together...seems like a permanent solution?..... Link to comment Share on other sites More sharing options...
Seaking Posted October 3, 2010 Share #2 Posted October 3, 2010 Removed the fairing, (easy) and cleaned the audio plug with pin cleaner....if it happens again, what is the harm in doing away with the plug and soldering the wires together...seems like a permanent solution?..... Well the obvious problem would be how permanent it is.. I know it's not very often you have to unplug everything but when it comes time to do the neck bearings for example, what then? I had loose plugs before but with 4 pieces of zip ties was able to make a tightening harness for one of the plugs that cinched it up tight and resolved an issue or two.. Link to comment Share on other sites More sharing options...
MikeWa Posted October 3, 2010 Share #3 Posted October 3, 2010 No issues aside from the obvious if you ever need to remove anything. I suggest you would be better off with cleaning and a liberal dose of dielectric grease. But that is just my opinion. Mike Link to comment Share on other sites More sharing options...
etcswjoe Posted October 3, 2010 Share #4 Posted October 3, 2010 You could always change out the connectors to a locking weather resistant type. Link to comment Share on other sites More sharing options...
Woody Posted October 4, 2010 Share #5 Posted October 4, 2010 dielectric grease and zip ties are great. Link to comment Share on other sites More sharing options...
Seaking Posted October 4, 2010 Share #6 Posted October 4, 2010 I got a couple of emails from folks asking HOW to tighten the connection with 4 zip ties.. so I'll post it here also to help others who might be in need.. It works for me, but i didn't do it on the new warranty replacement radio yet.. erk! You zip tie around each cable of the connector, a little loose so you can slip another zip tie between it and the cable. Do up the cable connector.. Now, simply zip tie the previous two zip ties together which pulls the connectors tight together. To remove, simply snip off the last two you put on.. Does that make sense without a drawing? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now