bmxndad Posted September 12, 2009 Posted September 12, 2009 Has anyone ever straightened out the toe side of the shifter? Move it in towards the engine. It seems like it would clear up some room on the floorboard for setting the foot. Doing this might make it hard to get your toe on it. By the way, I always use both the heel and the toe.
boominup Posted September 12, 2009 Posted September 12, 2009 HMMM! Gotta check that out! I just installed a set of AirWings and that did take a little bit of room away for shifting. Brian
skydoc_17 Posted September 12, 2009 Posted September 12, 2009 The bending the shifter part is not a hard thing to do, it's the breaking the chrome plating part that would be the bummer! Place the shifter in a large vise and place a bar of steel (or Brass) round stock perpendicular to the shifter and close the vise. The steel shifter material is pretty soft(mild steel) but the chrome plating is not very flexible at all. Good luck with this project, Earl
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now