Squeeze..........Need Your Help

[Aussie Annie]

Squeeze,

 

A while back a comment was made about the hand-control for the back brake(for disabled riders) that SPEIGLER makes and you offered to help me if I needed it...........guess what?? I NEED IT!!

 

It is going to be safer if I can put the back brake up onto the handlebars--as my right foot needs to sit where the brake pedal is. Can you get me any information about it:think: You said the factory was not far from you, and I would appreciate any help okay:bowdown:

[Squeeze]

Sure Annie, no Problem, my Pleasure to help.

 

Would you please sent me a Picture of your Bikes rear Brake Calipers, one from the full Side and one from behind where the the Pads go into the Caliper ?

 

I'll call them on Monday and figure this out for ya. I'll PM you my Email Addie for the Pics.

 

What Handle bar do you use ? Stock, this is a 1 Inch Diameter on the 2Gens. Didi you mount a different Handlebar and/or other Struts ? Because, you'll need a long Brake Line to connect this Thumb Master Cylinder and the rear Caliper. Best Option would be to take a Rope and hold it to the extimated Position of the Thumb M/C and feed the Rope to the Caliper on a safe Route, then cut the Rope, pull it out and measure the Lenght.

 

 

What Side do you prefer ? Usually, this Thumb M/C goes to left Side on the Handle Bar.

[Aussie Annie]

Squeeze-thank you for this I have Flanders handlebars, which are 1 inch.

The hand control will be going on the left side.

 

Measured from rear caliper, through bike, and to handlebar= 2.72 meters (for brake line)

 

Alan took panniers off and took these pics, hope they are okay?( Pics 2 & 3 were taken looking through the wheel, from the other side)

[Squeeze]

Annie, thats way more than good enough Info. I'll get after Spiegler on Monday Morning.

[Aussie Annie]

Squeeze Got the info for Spiegler, will wait to see if info from Sweden any different.

 

This club is amazing