Kuryakyn Iso Pegs?

[naturbar]

I have an 07 RSTD, we measured the crash bar diameter is it appears to just a tad under 3/4". the smallest diameter that i see for Kuryakyn Iso Pegs are 1". anyone here with a rstd have these pegs and if so what is the part # and will i need to make a shim ? Thanks in advance for any help/suggestions.

Another thing, i'm buying the Hoppe Quadzilla fairing for my bike and i would like to add passing lamps (or light bar which ever you prefer) and need ideas/suggestions also.

[M61A1MECH]

I used Longhorn offest cruise peg mounts P/N 7980 on my

07 Venture, they have 1" quick clamps and work just fine.

 

Try this link

http://www.kuryakyn.com/index.cfm/go/Home.ProductDetail/IMID/460

[georgew48]

That is the same ones I use on my 06 RSTD and they work great.

[Jethroish]

Used the 1" clamps on my Venture.

 

On another bike, I had th 1 1/4" clamps and 1" bar. I had some rubber gasket material so I cut it to wrap the bar with before putting the clamp on. Never had a problem with slipping.

 

I would bet the 1" quick clamps will work just fine.

[naturbar]

thanks guys for the help & part # - at least now i know what diameter size to purchase.

[Uturn]

I needed a spacer in the Kuryakyn 1" clamp. I used a couple pieces of plastic wire ties cut about 1 inch long and slid them in, then tighten. Works great.

 

MIKE aka Uturn

 

[davecb]

The crash bars are 1" diameter....

 

 

 

 

[hunts4beer]

I just ordered a set of the longhorn offsets last week for my '06 RSTD. Being the thrifty shopper that I am I always try and make sure I get the best price available. My wife has a couple of other phrases she uses instead of thrifty but you get the point. Anyhow, I was able to get them delivered to my door for a hundred bucks from A & B Xtreme out of Ohio. You can contact them at 740-676-2900.