Shifter adjustment?

[Shipper]

Is it possible to adjust the angle of the shifter? I need the toe lower and the heel higher. I see an adjustment screw (?) just forward of the pivot point. Bike is new and have had some problems going in 1st past neutral when downshifting to a stop. I have also had an incident when shifting up using the heel shifter. The neutral problem makes me move the clutch handle out to help shift down to 1st (not a good feeling when sitting at a stop light). Any suggestions? Thanks!

[jfoster]

If I understand you right...if your wanting to adjust the height of the shifter. You can loosen the adjustment nuts and turn it in either direction to either raise or lower it. Once you get it to your liken, tighten the nuts back out.

[Squeeze]

BUt watch out, one of them Nuts is a left handed Thread.

[Shipper]

If I understand you right...if your wanting to adjust the height of the shifter. You can loosen the adjustment nuts and turn it in either direction to either raise or lower it. Once you get it to your liken, tighten the nuts back out.

 

That's what I want to do. After the adjustment I'll see if that helps my "neutral" problem. I'll be careful about the left handed nut. Thanks!

[tazmocycle]

if that don't get it to where you want it, you can take out the bolt on the back of shifter, pull it out away from bike and move it a little till it splines back up and then put bolt back in and tighten it.