fairing pins

[StuD]

Somebody "pre-crash" posted a fix for pins broken off of fairing. I've searched, cant find it, hope its not lost. If memory serves it was a metal grease nipple gizmo........yikes......help..:canada:

[Eck]

I think this is what your asking for....

 

http://www.venturerider.org/forum/showthread.php?t=20293

 

 

If not, how about this...

 

http://www.venturerider.org/forum/showthread.php?t=516

Edited March 3, 2009 by Eck

[6m459]

http://www.venturerider.org/forum/showthread.php?t=8181

[Venturous Randy]

The best fix I have found is Industrial Strength Velcro. Clean both surfaces and put the Velcro on and it works great.

RandyA

[CrazyHorse]

I still had the broken pins stuck in the rubber holder. I abs glued them and then drilled thru them and put the machine screw thru it and tied into a small nut on the bottom that was loctited.

[bobcat]

Stud...I completely remove the old nipple from the base..I then drill the appropriate sized hole in the base and install a 5mm allen head screw that I nut on both sides of the base...The allen head is about the same size as the plastic nipple head and fits nicely in the rubber grommet....

[StuD]

Stud...I completely remove the old nipple from the base..I then drill the appropriate sized hole in the base and install a 5mm allen head screw that I nut on both sides of the base...The allen head is about the same size as the plastic nipple head and fits nicely in the rubber grommet....

 

I have that tecknolegy I'll give it a go Thanks :canada: