Risers for a RSV question

[jvbailey3]

I have purchased a set of risers based on all the wonderful information on the site. My question is, do the bolts have to be torqued? Not that I know much about anything mechanical, but would like to ensure that the handle bars don't come off because I didn't tighten them enough. As always, thanks for all the wonderful help.

[jburrell]

Yep,Yep,

Handlebars coming off would not be a good thing. Check the service guide and it will tell you if there is torque specs. If not, use blueor red loc-tite on the threads to help keep them tight. You can find a service manual on this site.

[KiteSquid]

If you don't have it, the factory service manual is available for FREE in PDF format.

 

look for the VRTech link on the left side of every page here at the GREATEST RSV forum!!!!!

[RedRider]

Yep,Yep,

Handlebars coming off would not be a good thing. Check the service guide and it will tell you if there is torque specs. If not, use blue or red loc-tite on the threads to help keep them tight. You can find a service manual on this site.

 

Use Blue Loctite. Since you may want to adjust your handlebars after you install them (up or down) and get a chance to test the fit, RED loctite would prevent you from ever removing them (without heat - not good for chrome). Also, you occasionally will need to remove the handlebars for maintenance (lubing steering head bearings come to mind). Just use BLUE.

 

FYI - I just cranked down on the bolts until they were good and tight. They haven't moved in a year of riding.

 

RR