Ga Dawg Posted December 23, 2008 #1 Posted December 23, 2008 Just replaced clutch disks and clutch lever is tight and will not squeeze. I may have squeezed it while the disks where off and no pressure plate or retainer screws where in place. What do I do? What would have this thing hemmed up to where clutch will no work? I am stumped!!! Would someone please spread some great clutch knowledge my way? You guys are great!!Thanks!!!!!!
BradT Posted December 23, 2008 #2 Posted December 23, 2008 Pull the cover and push (hard) the centre push rod back into position, it should slowly slide back into position. Then check the pressure plate is lined up properly. The splines have to lined up, keeping it all together. This is assuming all the other parts are back together properly. Good luck BRad
Yammer Dan Posted December 23, 2008 #4 Posted December 23, 2008 Froggie and I know all about that one!!!
FROG MAN Posted December 23, 2008 #5 Posted December 23, 2008 Never forgot it either. Like to be working on something now but dang it's cold outside.
Yammer Dan Posted December 23, 2008 #6 Posted December 23, 2008 I think the warden took a Grandkid to bed with her just to keep me on my good behavior!! Gonna stay cold!!
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now